Autocue USB Controller For Use With QPro Manuel d'utilisateur télécharger pdf

Configuring The New DLP 2-button USB Controller For Use With QPro

Step 1: Installing the driver

A) Install the driver here: ftp://ftp.autocue.com/Drivers/Windows_DLP_Drivers.exe

B) Plug the controller into the PC and open the Windows device manager.

-This can be found on Windows XP under Start, Settings, Control Panel, System, Hardware tab

-Windows 7: press start and type “Device Man” and enter to select Device Manager in Windows

-Windows 8: press start then click to filter by “Settings” and type “Device Man” there and you will see it to click.

C) In the picture below you can see I have determined that the controller is using COMM 3.

Note: in some cases the driver will not load automatically. If this is the case and you have an unrecognized device in

Windows try a different USB port. If still no joy right-click on the unrecognized device and select to update driver. Then

pick the extracted contents of this zip file here.

1 2

Page 1

Configuring The New DLP 2-button USB Controller For Use With QPro Step 1: Installing the driver A) Install the driver here: ftp://ftp.autocue.com/D

Page 2

Step 2: Selecting the controller in QPro A) Launch QPro B) Go to “Help” and “About” and verify that you are running build 2059 or later. If earlier

Pas de commentaire

Autocue USB Controller For Use With QPro Manuel d'utilisateur